“Pistol Repair 101: Get Your Magazine Spring Back in Action!”

How to Identify the Right Magazine Spring for Your Pistol

If you’re looking to replace the magazine spring in your pistol, you’ve come to the right place! Replacing the magazine spring is an important part of maintaining your firearm, and it’s important to make sure you get the right one for your pistol. Here are a few tips to help you identify the right magazine spring for your pistol.

First, you’ll need to know the make and model of your pistol. This information can usually be found on the slide or frame of the gun. Once you have this information, you can search online for the correct magazine spring for your pistol.

Second, you’ll need to measure the length of the magazine spring. This can be done by measuring the length of the spring from the base to the tip. Make sure to measure the spring when it is compressed, as this will give you the most accurate measurement.

Third, you’ll need to determine the type of magazine spring you need. There are two main types of magazine springs: flat and coil. Flat springs are usually found in single-stack magazines, while coil springs are usually found in double-stack magazines.

Finally, you’ll need to make sure the magazine spring you purchase is compatible with your pistol. Many manufacturers make magazine springs that are specifically designed for certain models of pistols. Make sure to double-check that the spring you purchase is compatible with your pistol before you buy it.

By following these tips, you should be able to identify the right magazine spring for your pistol. Remember, replacing the magazine spring is an important part of maintaining your firearm, so make sure to get the right one for your pistol!

Step-by-Step Guide to Replacing a Magazine Spring

1. Start by removing the magazine from the gun. Make sure the gun is unloaded and the safety is on.

2. Unscrew the base plate of the magazine and remove it.

3. Carefully remove the magazine spring and follower from the magazine body.

4. Take the new magazine spring and follower and insert them into the magazine body.

5. Make sure the spring is properly seated and the follower is in the correct position.

6. Replace the base plate and screw it back into place.

7. Test the magazine by inserting it into the gun and cycling the action. Make sure the magazine is feeding properly.

8. If everything is working correctly, you’re done! Enjoy your new magazine spring.

Common Issues to Look Out for When Replacing a Magazine Spring

When replacing a magazine spring, there are a few common issues to look out for. First, make sure that the spring you are using is the correct size for the magazine. If the spring is too long or too short, it can cause feeding issues.

Second, make sure that the spring is properly seated in the magazine. If the spring is not seated correctly, it can cause the magazine to jam or not feed properly.

Third, make sure that the spring is not bent or damaged. If the spring is bent or damaged, it can cause the magazine to jam or not feed properly.

Finally, make sure that the spring is properly lubricated. If the spring is not lubricated, it can cause the magazine to jam or not feed properly.

By following these simple steps, you can ensure that your magazine spring replacement goes smoothly and that your magazine will feed properly.